メインコンテンツへスキップ

easYgen-3000XT with J1939 speed bias to ECU of FPT/IVECO model "MD1" - ナレッジベース / easYgen-3000XT / communication - Power Generation

easYgen-3000XT with J1939 speed bias to ECU of FPT/IVECO model "MD1"

作成者一覧

ECU brand: FPT / IVECO
ECU model: MD1

Here speed bias through J1939 communication works only with easYgen-3000XT having version 2.12 or higher

easYgen-3000XT, with version 2.12 is prepared to have an additional ECU selection called "Standard C"

This does include the mandatory Checksum and Counter values for that kind of ECU.
(The J1939-Standard does not state the values as mandatory, but the MD1 actually does!!!)

  1. Update your easYgen-3000XT to version equal or higher than >>2.12-1<<
    Firmware files available here: https://wss.woodward.com/manuals/Support/Forms/AllItems.aspx

  2. Set parameter at "Configure Application -> Configure Controller -> Frequency controller" as follows...
    1630567945614.png

  3. Set parameters at "Configure Interfaces -> CAN 2 -> J1939" as follows...
    1630567577527.png

  4. Finally re-boot the easYgen, see Parameter #10419 above.